Directive 2017/774 - Commission Directive 2017/774 amending, for the purpose of adopting specific limit values for chemicals used in toys, Appendix C to Annex II to Directive 2009/48/EC on the safety of toys, as regards phenol - Main contents

EN

Official Journal of the European Union

L 115/47

In order to ensure a high level of protection of children against risks caused by chemical substances in toys, Directive 2009/48/EC establishes certain requirements with regard to chemical substances such as those classified as carcinogenic, mutagenic or toxic for reproduction (CMR) under Regulation (EC) No 1272/2008 of the European Parliament and of the Council (2), allergenic fragrances and certain elements. In addition, Directive 2009/48/EC empowers the Commission to adopt specific limit values for chemicals used in toys which are intended for children under 36 months and in other toys intended to be placed in the mouth in order to ensure adequate protection in the case of toys involving a high degree of exposure. The adoption of such limit values takes the form of an inclusion in Appendix C to Annex II to Directive 2009/48/EC.

For a number of chemicals, currently applicable limit values are either too high in the light of available scientific evidence or do not exist. Specific limit values should therefore be adopted for them, taking into account the packaging requirements for food as well as the differences between toys and food contact materials.

In order to advise the European Commission in the preparation of legislative proposals and policy initiatives in the area of toy safety, the Commission established the Expert Group on Toys Safety. The mission of its subgroup ‘Chemicals’ is to provide such advice with regard to chemical substances which may be used in toys.

Phenol (CAS number 108-95-2) is used as a monomer for phenolic resins in the manufacture of resin-bonded wood (3) for toys. The degradation of phenolic antioxidants in polymers can be a further source of phenol in toys (4). Phenol was identified in emissions from game consoles (5), in one of six analysed tents or tunnels for children (6) and in packaging film (7), it was tested in bath toys and other inflatable toys (8), and it was considered to be present in polyvinyl chloride (PVC) (9). Phenol could further be used as a preservative in water-based liquid toys such as bubble-blowing products or water-based liquid inks (e.g. felt-tipped marker pens) (10).

In its deliberations on phenol the subgroup ‘Chemicals’ took European standards EN 71-9:2005+A1:2007, EN 71-10:2005 and EN 71-11:2005 as the basis. Those standards refer to the presence of phenol in toy materials (EN 71-9:2005+A1:2007) and provide specific methods of sample preparation (EN 71-10:2005) and measurement (EN 71-11:2005). EN 71-11:2005 repeats and details the limit values for phenol in toy materials set in EN 71-9:2005+A1:2007, namely 15 mg/l (migration limit) for phenol as a monomer and 10 mg/kg (content limit) for phenol as a preservative in liquid toy materials.

The subgroup ‘Chemicals’ also took account of the recommendation of the Scientific Committee on Health and Environmental Risks (SCHER) that the migration limit value of 15 mg/l for phenol set out in the existing European standard be lowered at least by a factor of 2 in order to reach a Margin of Exposure of 100 that could be considered sufficiently large (11).

The subgroup...